Viola Systems Spirito Reference Series Preamplifier Manual de usuario Pagina 5

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 10
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 4
The Viola Legacy mono power amplier is capable of
delivering 100 watts of Class A power into 16, 8, 4 and 2
ohms. The Legacy is fully balanced design with very low
distortion, wide dynamics and reproduction of low level
detail. Class A operation eliminates crossover distortion
inherent in Class B and Class AB designs.
Legacy Audio Design
The Legacy is a Class A biased push-pull amplier that utilizes
low global feedback. Two matched power amplier modules
that are driven into a center-tapped output transformer. This
allows fully balanced operation from input to output. Soft
clipping circuitry limits sonic degradation should the amplier
be overdriven. The Legacy is capable of switching to Class AB
to deliver more power into demanding loads while still pre-
serving subtle aspects of the music signal. The Legacy is
protected against overvoltage, over temperature, excessive
current and DC offset.
Legacy Power Supply
As with all Viola ampliers designs, the Legacy features a
choke input power supply. The Legacy power supply reduces
high charging currents that are prevalent in capacitor input
supplies. This minimizes intermodulation distortion on the
power supply rails and ground returns. This also has the
benet of reducing stress on the power supply components.
Onboard decoupling capacitors eliminate wire inductance
along with lm capacitors provide a uniformly low power
supply impedance.
Viola Legacy Specications
Class of Output Operation A
Power Rating 100W continuous average power into 16, 8, 4,
and 2 ohms 20 Hz to 20 kHz at less than
0.25% THD
IM Distortion (SMPTE) 1W to 100W <0.01%
THD <0.08% @ 20 kHz/100 watts
Frequency Response 1W into 8 ohms (10Hz – 20kHz) +/-0.25 db;
100k <-3db
Power Bandwidth 5 Hz to 100 kHz (-3dB points)
SN Ratio <-110 db at 1 kHz / 100W; C weighted
Gain 26 dB
Input Impedance 1M Ohm / 1M Ohm balanced
Inputs 2 x Balanced – XLR
Output Connections 1 pair of binding posts for spade terminals for
each impedance tap
Power Consumption Approximately 450W at idle
Weight Amplier 168 lbs. (76.2kg)
Dimensions Height w/feet 12 3⁄16’’ (31.0 cm)
Width 17 9⁄16’’ (44.6 cm)
Depth w/binding posts 26 1⁄2’’ (67.3cm)
© Viola Audio Labs 2010
4
CLASS A MONO POWER AMPLIFIER
LEGACY
Vista de pagina 4
1 2 3 4 5 6 7 8 9 10

Comentarios a estos manuales

Sin comentarios